MakerWorld
Electronics
Zum Modell
Nintendo GameCube (Switch 2) controller stand
413
Downloads
115
Likes
348
Makes
I made this stand for my nintendo switch 2 gamecube controller. Since it's the same shape as the original it also works for original gamecube controllers (except the wavebird ofcourse) I expect it to also work with similar shaped 3rd party controllers. I made it so the arm clicks into the base, no glue should be needed but if it's a bit loose just glue it down. The longer end of the arm is the front :)Boost MeIf you liked this print consider giving it a boost :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
