MakerWorld
Other Toys & Games
Zum Modell
Nintendo Switch 2 Pro controller ? cube stand
929
Downloads
418
Likes
494
Makes
Nintendo Switch 2 Pro Controller stand - Mario question mark cube controller stand Remixed (I started designing it from scratch, but would have ended up exactly the same!) from a question mark cube by giuliomaffei90 to hold the new Switch 2 Pro controller. This does fit the original Pro controller too, however there is a wiggle room either side, where it's a snugger fit for the Switch 2 controller (new controller is not as wide between the two grips as the original one).Boost MeIf you like this print, please consider a boost, it's a great way of supporting creators on here. Printing This will require an AMS to print. I printed this with the textured PEI plate and white and yellow filament. The print profile should cover everything else.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
