Thingiverse
Nintendo Switch Mount
von GameHippie
42
Downloads
41
Likes
0
Makes
I was laying in bed one night holding my Nintendo Switch a foot above my face when it finally clicked, "I need a mount for this!". I knew if I could design a reliable mount, I could then attach it to a gooseneck I had laying around and then easily and comfortably play games in bed. I can now detach my joycons and enjoy gaming in the laziest of ways! I even put a hole in for the charge cable that I will run through the gooseneck. It fits my switch perfect and the little nub on the bottom grabs and holds the switch in place.
I designed the gooseneck mount to be separate from the switch mount so I could reuse the design for other scenarios and so others could use it to meet their needs. If you come up with a great 'attachment' please share it as a remix.
The mount plate is 6mm thick, while the 2 screw holes are 10mm apart (from center) and have a diameter of 3.25mm. Using that information and your own CAD software you should be good to go. The screws I used fit well within the plast
I designed the gooseneck mount to be separate from the switch mount so I could reuse the design for other scenarios and so others could use it to meet their needs. If you come up with a great 'attachment' please share it as a remix.
The mount plate is 6mm thick, while the 2 screw holes are 10mm apart (from center) and have a diameter of 3.25mm. Using that information and your own CAD software you should be good to go. The screws I used fit well within the plast
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!