Thingiverse
Nintendo Switch Pro Controller Wall Mount
door lasercharly
3
Downloads
2
Likes
0
Makes
Tested with 4mm plywood on a Sculpfun S10 Lasercutter with Air Assist enabled (not necessary).
Lightburn settings:
---------------------
* Speed: 480 mm/min
* 100% constant laser power
* 3 to 4 passes
Construction Notes
---------------------
Apply wood glue to seven of the eight pieces (no glue for the frontpiece!) and glue them together, the guide rails at the top and bottom should help it fit properly.
after the glue is completely dry, carefully finish drilling the two holes.
can be attached anywhere with two screws or a suitable piece of double-sided tape.
Lightburn settings:
---------------------
* Speed: 480 mm/min
* 100% constant laser power
* 3 to 4 passes
Construction Notes
---------------------
Apply wood glue to seven of the eight pieces (no glue for the frontpiece!) and glue them together, the guide rails at the top and bottom should help it fit properly.
after the glue is completely dry, carefully finish drilling the two holes.
can be attached anywhere with two screws or a suitable piece of double-sided tape.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
