Thingiverse
Nook Simple Touch Case
von nolan879
3
Downloads
10
Likes
1
Makes
Snap on case for the Nook Simple Touch, and Simple Touch with Glowlight that covers the sticky rubber back.
Case show be installed bottom to top, the top clips show be flexed back slightly to allow them to snap into the top slots.
For best results print with the back of the case on the build plate.
The 2mm green stripe was added using Bambu handy, set at 7mm height.
Case show be installed bottom to top, the top clips show be flexed back slightly to allow them to snap into the top slots.
For best results print with the back of the case on the build plate.
The 2mm green stripe was added using Bambu handy, set at 7mm height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
