Thingiverse
Note10+ bedside table holder
par tristanceddia
49
Téléchargements
40
Likes
0
Makes
Couldn't be bothered always picking my phone charger off the ground to put into the phone, so I made this with OnShape. Printed with 20% infill on its back within Simplify3d with no raft. You will need to make sure you have supports.
The holder fits the Samsung Note 10+ with the clear case it comes with in the original packaging and the Samsung original charger fits tight into the bottom section.
A phone with a similar case may also fit. The bottom allows for 12mm thickness and the top drops a little tighter to 10mm to hold it snug in place.I attached the holder with heavy duty double sided tape to my bedside table.
Took my Ender 3 1 hour and 12 minutes to print at .2mm layer height
EDIT: I've uploaded a version for the official Samsung standing case. Dimensions of fit is 81mm x 13.4mm (w,d). If you do print this, can you tell me how it fits. I've estimated the charging port location by looking at images.
Thanks
The holder fits the Samsung Note 10+ with the clear case it comes with in the original packaging and the Samsung original charger fits tight into the bottom section.
A phone with a similar case may also fit. The bottom allows for 12mm thickness and the top drops a little tighter to 10mm to hold it snug in place.I attached the holder with heavy duty double sided tape to my bedside table.
Took my Ender 3 1 hour and 12 minutes to print at .2mm layer height
EDIT: I've uploaded a version for the official Samsung standing case. Dimensions of fit is 81mm x 13.4mm (w,d). If you do print this, can you tell me how it fits. I've estimated the charging port location by looking at images.
Thanks
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
