Nvidia Shield Wall Mount

This is a remix of the shield tablet holder with screw holes for a standard US single gang electrical box. This holds the tablet very securely against the wall with just a few mm of spacing. You can use the hole in the back to pass through tiny power wires.

I found out a little bit too late that the print wouldn't fit on the bed of my printer so I made a broken out version that "puzzle pieces" together. Since the load is all in the same plane as the back I assembled mine without glue. You could either glue it or use heat to fuse the back together or just let friction hold it as I have.

I printed with black PETG so it won't warp or give over time. I used .12 fine to make a nicer looking print but probably a larger layer height would work as well.