Thingiverse
octopi stand
di jacktheshaft
0
Download
0
Likes
0
Makes
basic webcam stand. intended to use a little redneck engineering to mount device. i just duct taped it on there. use your imagination or just remix.
its a little wide for the raspberry pi so just scale it in your slicing software
the holes might get a little rough without supports but its fine to just send it as is.
i just whipped this together real quick on fusion 360 as i am learning the program & was looking for something practical to design.
its a little wide for the raspberry pi so just scale it in your slicing software
the holes might get a little rough without supports but its fine to just send it as is.
i just whipped this together real quick on fusion 360 as i am learning the program & was looking for something practical to design.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
