Thingiverse
Oculus Quest Stand
von JorgTheElder
32
Downloads
21
Likes
0
Makes
This is a simple display stand for my Oculus Quest.
To make it a bit easier to print, the base can be attached by screws or printed in place.
It can be made with and without the wide base. I prefer it with the base. There are 6x1 threaded screw holes in the legs to attach the base if you do not want to print the single piece one. (I recommend running a 6x1 tap into the legs before attempting to use a screw.)
If you do want to use it without the base, be sure to use the one with the support ring so the legs don't break too easily.
To make it a bit easier to print, the base can be attached by screws or printed in place.
It can be made with and without the wide base. I prefer it with the base. There are 6x1 threaded screw holes in the legs to attach the base if you do not want to print the single piece one. (I recommend running a 6x1 tap into the legs before attempting to use a screw.)
If you do want to use it without the base, be sure to use the one with the support ring so the legs don't break too easily.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
