Thingiverse
Oculus Rift Controller Holder
von banjodan
24
Downloads
14
Likes
0
Makes
Got tired of my motion controllers rolling about my desk so I drew up this handy little holder. The design is simple enough; the slots are sized to fit the controllers as shown in the picture.
Since I'm a novice at printing I got a bit of warping at the corners so maybe I'll also make a round one of these and see if that helps.
Happy Printing!
-Banjo
Since I'm a novice at printing I got a bit of warping at the corners so maybe I'll also make a round one of these and see if that helps.
Happy Printing!
-Banjo
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
