Odin

It is possible to print without material system by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  You may print at higher layer heights below the Min Depth of 0.56mm  The Max Depth is 1.8mm and the Actual Depth is 1.8mm Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo + White Transmission Distance: 6 This print uses 3 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Gray At layer #13 (1.12mm) swap to White for the rest.