Thingiverse
Offset Funnel
von jakertbaker29
0
Downloads
0
Likes
0
Makes
This is an offset funnel for a round charcoal smoker. I made it so I could actually reach the steam pot through that tiny door without burning my knuckles or playing smoker Tetris.
I printed it in PETG because that’s what I had lying around—and I’m working with an Ender 3, so nothing too fancy here. If you’ve got something like nylon for better heat resistance, go for it, but PETG has been doing the job just fine for me.
No supports needed, just standard print settings, maybe a nice lil brim. It’s a pretty straightforward print that makes filling the smoker water a little less annoying.
I printed it in PETG because that’s what I had lying around—and I’m working with an Ender 3, so nothing too fancy here. If you’ve got something like nylon for better heat resistance, go for it, but PETG has been doing the job just fine for me.
No supports needed, just standard print settings, maybe a nice lil brim. It’s a pretty straightforward print that makes filling the smoker water a little less annoying.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
