OGX360 Case

Update:

I did a small update on the design arround the usb micro output since I discovered that with some cables that I did not get a good connection. The wall on the micro usb side is thinner now to make room for any usb connector. I will continue to make it bether so if you have any wishes do contact me :)

Print settings: (Prusa MK2.5)

0.2mm Layer height
5% infill
Honeycomb infill
Permiters 2
5 top 4 bottom layers

The case was printed in Silver prusa PLA, and transparent on the lid to get the glowing effect for the text.

Thanx to Ryzee119, head over to github for more info on this project.
And if you print it please upload a picture.

https://github.com/Ryzee119/ogx360

Enjoy!