Thingiverse
Olympus FL-LM3 flash diffuser
por snapwithdale
47
Descargas
30
Likes
1
Makes
Little flash diffuser for the flash that comes with the Olympus OMD M5 mkii. It slips on and grips it slightly so is unlikely to fall off (based on how my printer produced it).
One side is vertical and the other is at an angle. So you can experiment with mounting it in both directions to get a slightly different result (I assume).
I printed with ABS. I'm sure PLA would be fine too, as this flash hardly gets hot. I went with white for a white light. If you printed with another color then that's going to change the flash color. Let me know if anyone experiments with another color! I think I might try a bright blue one to see if it make a cool color tone. Good times.
No supports needed. Make sure you print it top side down.
One side is vertical and the other is at an angle. So you can experiment with mounting it in both directions to get a slightly different result (I assume).
I printed with ABS. I'm sure PLA would be fine too, as this flash hardly gets hot. I went with white for a white light. If you printed with another color then that's going to change the flash color. Let me know if anyone experiments with another color! I think I might try a bright blue one to see if it make a cool color tone. Good times.
No supports needed. Make sure you print it top side down.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
