OnePlus 6 Rear Camera Cover

A sliding window camera cover for the OnePlus 6 that is held in place by the phone's case (the official case that comes with the phone), so you don't have to glue it to the phone.

-----------------------------

### __Print Settings__

** A GCODE file for the Creality Ender 3 ready for print is included **

Print all 3 STL files:
- Cover.stl
- Rail-bottom.stl
- Rail-top.stl

** It is important to change the line height to 0.1 since this is a very thin print and every layer counts. **

In addition, in order to successfully print this, I tinkered with the slicing settings and ended up with the following custom settings:
- ** Initial Layer Speed: 10 mm/s (important) **
- Initial Layer Flow: 120% (might have made a difference)
- Flow: 120% (might have made a difference)
- Printing Temperature: 205C (might have made a difference)

A friendly tip: When the print is done, don't remove the parts off of the printer's bed before letting it cool off a bit. The parts are very