OneUp Bed Replacement

This is the beginning stages of a major overhaul of the OneUp 3D Printer.

Print both a front and a back piece, then replace the original bed mount with these parts. I will upload better pictures later.

If you do not have a long enough belt to fit into the M3 belt clamps, you may need to find a source for longer belt (or replace the current with a GT2 belt and pulley [prefered]).

You will also need zip ties to attach the linear rods.

I printed these parts on my OneUp at a 45 degree angle to make them fit on the print bed. These parts are currently being used on my OneUp printer.