Thingiverse
Tools
Zum Modell
Open Beam Corner Bracket
301
Downloads
200
Likes
1
Makes
Remix of Wired1's Open Beam Corner Plate. I removed the inner-most holes and put a stopper in the middle instead.
Ver 0 has the holes in the bottom open, but if this makes it hard to print, ver 1 has the holes close and you will need to drill/push through after printing.
Ver 0 has the holes in the bottom open, but if this makes it hard to print, ver 1 has the holes close and you will need to drill/push through after printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
