Thingiverse
Open esk8 Remote Controller
by McNugget
16
Downloads
36
Likes
0
Makes
Open electric skateboard remote for NRF24L01+ based remote controller designs.
Most Chinese boards use this NRF chip to communicate with the remote until end of 2018. It's a Chinese no name motor controller that comes with a remote and can be configured to run four motors.
NOT COMPATIBLE WITH THE NEWER HOBBYWING BLUETOOTH BASED CONTROLLERS!
The detailed description can be found on my HackaDay project page. https://hackaday.io/project/161730-open-esk8-remote-v1
I reverse engineered the communication protocol between the board and the remote and implemented my own code based on an Arduino Nano. I build my own PCB around the selected components and stuffed everything into a nice, solid enclosure that fits nicely into my hand, even for long rides.
I printed the parts with the hollow side down and used support. I printed in PLA and the prints came out nicely! The support is a bit hard to remove but the reward was great!
Most Chinese boards use this NRF chip to communicate with the remote until end of 2018. It's a Chinese no name motor controller that comes with a remote and can be configured to run four motors.
NOT COMPATIBLE WITH THE NEWER HOBBYWING BLUETOOTH BASED CONTROLLERS!
The detailed description can be found on my HackaDay project page. https://hackaday.io/project/161730-open-esk8-remote-v1
I reverse engineered the communication protocol between the board and the remote and implemented my own code based on an Arduino Nano. I build my own PCB around the selected components and stuffed everything into a nice, solid enclosure that fits nicely into my hand, even for long rides.
I printed the parts with the hollow side down and used support. I printed in PLA and the prints came out nicely! The support is a bit hard to remove but the reward was great!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!