Thingiverse
Open Hex Tool
von wisestone
3
Downloads
3
Likes
0
Makes
To repair my flashlight I had to dissassemble a section of the inside chamber holding the LED in-place. This hex shaped piece would not undo with any tool that I had and there was no way to grip it without leaving plier marks, or worse.
A tool to undo the hex shaped piece seemed simple enough to design and 3D print. 20 minutes later I had the 3D part designed and printed and it worked without an issue.
My print is made in PETG 1.75mm 3DFillies black filaments, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.
I hope you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
A tool to undo the hex shaped piece seemed simple enough to design and 3D print. 20 minutes later I had the 3D part designed and printed and it worked without an issue.
My print is made in PETG 1.75mm 3DFillies black filaments, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.
I hope you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
