Thingiverse
Open Hex Tool
by wisestone
3
Downloads
3
Likes
0
Makes
To repair my flashlight I had to dissassemble a section of the inside chamber holding the LED in-place. This hex shaped piece would not undo with any tool that I had and there was no way to grip it without leaving plier marks, or worse.
A tool to undo the hex shaped piece seemed simple enough to design and 3D print. 20 minutes later I had the 3D part designed and printed and it worked without an issue.
My print is made in PETG 1.75mm 3DFillies black filaments, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.
I hope you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
A tool to undo the hex shaped piece seemed simple enough to design and 3D print. 20 minutes later I had the 3D part designed and printed and it worked without an issue.
My print is made in PETG 1.75mm 3DFillies black filaments, with 0.2mm layer height and 100% infill on a PRUSA I3 MK3S printer.
I hope you can find this print useful, too.
Remember to leave me some feedback or even a tip to keep me enthused to make more of these drawings.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
