Thingiverse
Open Press Compatible Mods
von dddddyck
150
Downloads
122
Likes
1
Makes
Some modified parts compatible with Martin Schneider's amazing Open Press Project DIY etching press parts.
Rochat Style Drive Wheel
-Inspired by the original design of Harry F Rochat Ltd etching presses.
New Sidepart
-Sidepart modified to include a replaceable pressure pad at the high-wear location where the steel M5 fastener contacts the upper roller holder, and a bump up top also inspired by the look of the Rochat presses.
Table Extension
-Alternate bowtie connection designed to provide extended support to the press table. Each connector prints in two parts and uses a M4x8 allen bolt and M4 nut.
Clip-on wingnuts
-These might work for your press if you're using hex bolts. Files are available here.
Rochat Style Drive Wheel
-Inspired by the original design of Harry F Rochat Ltd etching presses.
New Sidepart
-Sidepart modified to include a replaceable pressure pad at the high-wear location where the steel M5 fastener contacts the upper roller holder, and a bump up top also inspired by the look of the Rochat presses.
Table Extension
-Alternate bowtie connection designed to provide extended support to the press table. Each connector prints in two parts and uses a M4x8 allen bolt and M4 nut.
Clip-on wingnuts
-These might work for your press if you're using hex bolts. Files are available here.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
