Thingiverse
Open Source Hardware Logo
von botdream
18
Downloads
29
Likes
0
Makes
This is my first attempt to make a 3d object using OpenSCad, InkScape, so decided to make this 8x8cm OpenSoftwareHardware logo.
Internal Legend turned out to be a bit to thin so that it could fit the logo, may need some extra cleaning, since I used this to fill with extra material it turned out to be fine.
Internal Legend turned out to be a bit to thin so that it could fit the logo, may need some extra cleaning, since I used this to fill with extra material it turned out to be fine.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
