Thingiverse
Openbeam cableguides
von Mizcak
3
Downloads
5
Likes
0
Makes
Cableguides designed to fit the Openbeam 15x15mm extrusions, without a nut in the slot.
When printed in ABS with a 0.4mm nozzle these snap in to the slots. A M2 screw or two may be used to further lock them in place if needed.
5-0: Guide on the side.
5-1: Guide on top
5-2: Guide on top, with an offset of 4.5mm. Nice when having a plastic sheet as a separator of sorts laying on the side of the extrusion, like in my printer enclosure. (shown in a photo)
No supports needed.
When printed in ABS with a 0.4mm nozzle these snap in to the slots. A M2 screw or two may be used to further lock them in place if needed.
5-0: Guide on the side.
5-1: Guide on top
5-2: Guide on top, with an offset of 4.5mm. Nice when having a plastic sheet as a separator of sorts laying on the side of the extrusion, like in my printer enclosure. (shown in a photo)
No supports needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![[v2.0] Prusa i3 X-axis lead screw upgrade](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2Ff1%2F44%2F30%2F89%2F3d%2Fv2.0_Printer_Assy_display_large.jpg&w=400&h=300)