Thingiverse
Openbeam cableguides
por Mizcak
3
Descargas
5
Likes
0
Makes
Cableguides designed to fit the Openbeam 15x15mm extrusions, without a nut in the slot.
When printed in ABS with a 0.4mm nozzle these snap in to the slots. A M2 screw or two may be used to further lock them in place if needed.
5-0: Guide on the side.
5-1: Guide on top
5-2: Guide on top, with an offset of 4.5mm. Nice when having a plastic sheet as a separator of sorts laying on the side of the extrusion, like in my printer enclosure. (shown in a photo)
No supports needed.
When printed in ABS with a 0.4mm nozzle these snap in to the slots. A M2 screw or two may be used to further lock them in place if needed.
5-0: Guide on the side.
5-1: Guide on top
5-2: Guide on top, with an offset of 4.5mm. Nice when having a plastic sheet as a separator of sorts laying on the side of the extrusion, like in my printer enclosure. (shown in a photo)
No supports needed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!