Thingiverse
Openbuilds Interface Holder
door I3dprint_stuff
16
Downloads
17
Likes
0
Makes
This is a holder for the Openbuilds interface.
In order to be functional, additional parts are needed:
4x M4 button head screws 16 mm long,
4x M4 nylon lock nuts,
6x 6 mm dia x 3 mm thick magnets (found here: https://www.amazon.ca/-/fr/gp/product/B07873ZCY4/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1)
Magnets are press-fit into recessed holes. It holds well, easy to pull out if needed to replace.
For the ''Interface_holder_part1'', you need to insert 4x M4 nylon lock nuts at 16,40 height layer. You need to set a pause in the Gcode at this layer in order to put the nuts. I used PrusaSlicer to set the pause to the desired layer.
In order to be functional, additional parts are needed:
4x M4 button head screws 16 mm long,
4x M4 nylon lock nuts,
6x 6 mm dia x 3 mm thick magnets (found here: https://www.amazon.ca/-/fr/gp/product/B07873ZCY4/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1)
Magnets are press-fit into recessed holes. It holds well, easy to pull out if needed to replace.
For the ''Interface_holder_part1'', you need to insert 4x M4 nylon lock nuts at 16,40 height layer. You need to set a pause in the Gcode at this layer in order to put the nuts. I used PrusaSlicer to set the pause to the desired layer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
