Thingiverse
OpenSCAD Y Bracket
von triffid_hunter
15
Downloads
18
Likes
0
Makes
Prusa's original DXF for his Y motor bracket made the curves too chunky for my liking, so I remade it in OpenSCAD. Now I can take full advantage of my firmware's jerk setting and get beautifully smooth curves at full speed.
I also added slots so that it's easier to install, or switch for my http://www.thingiverse.com/thing:15988 . They're oriented so that as much structural stiffness as possible is retained.
I also added slots so that it's easier to install, or switch for my http://www.thingiverse.com/thing:15988 . They're oriented so that as much structural stiffness as possible is retained.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
