Optics table wall mount

#Vertical wall mount for optics tables

##Small bracket designed to hold 5mm thick wall material in a vertical position
This easy to print bracket supports wall material, or alternatively thick cardboard, in a vertical position. Due to the support at the bottom, walls will be lifted approximately 2 millimeter off the airtable, so some customization is required for light-proof enclosures.

The slot in the bottom is designed for an M6 bolt, but should be wide enough to support 1/4" bolts as well. I recommend to utilize a washer with these to prevent cracking the plastic, and clearance has been provided around the slot for this.

Walls are supported on both sides with diagonal struts for extra rigidity, though are obviously not designed to hold any structural loads. Essentially, these supports are only designed for quickly screwing down a removeable barrier to block stray laserlight.