Thingiverse

Optocoupler: Updated

von IndustrialArtsandCraftsLLC

2 Downloads

3 Likes

0 Makes

An optocoupler is an electronic component that transfers electrical signals between two isolated circuits by using light. Insert and glue a 5mm LED (bright white) into the cavity on the LED side. Insert and glue a 5mm photo-resistor into the cavity on the LDR side. Glue/press-fit the LDR side into the LED side.

Important: Avoid obstructing the internal components as best you can. When connected correctly, the LED will emit light onto the photo resistor. The photo resistor's resistance will decrease when the LED is on and increase when off, and will vary depending on the light intensity.

100% infill and dark filament is recommended for complete opacity. Updated STL files have 1mm holes for LED and LDR leads.

arduino circuits circuitsetup diy DIY electronics electronics electronic component electronic components engineeringproject hands on learning LDR learning LED LEDs LED light optocoupler optoisolator photocoupler photoresistor project

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat