Orange Pi Win Plus Case

This is a remod based on Neodyme's works. Changes are listed here:

1. change screw hole to M3 and copper nut
2. add a 45*31*12mm heat sink window
3. update original grid window to hive window

-- ps --
The screw hole is a little small for the M3 copper nuts. Maybe you should enlarge the hole by 0.5mm. Also it is a little hard to iron it to the right place. But is works perfect after carefully fix.

-- pps --
About the development board, it is better to use a fast A2 tf card and a bigger heat sink.