Thingiverse
Electronics
Zum Modell
Orange Pi Zero 3 Snap Case
52
Downloads
101
Likes
3
Makes
This is a slim case that requires no screws for assembly. In fact, the clips on my printed version were so tight that I believe they are 'forever'.
Added some vents for heat, and I routed my antenna cable between the RJ-45 and USB ports. Wouldn't be difficult to disconnect the antenna and push it through a vent if desired.
Printing requires no supports, just place the flat side of each half on the print bed. To assemble, carefully guide the 4 clips to their slots.
**Update 08-23-2023** - added a version of the case top with a 16x16mm heatsink opening
Added some vents for heat, and I routed my antenna cable between the RJ-45 and USB ports. Wouldn't be difficult to disconnect the antenna and push it through a vent if desired.
Printing requires no supports, just place the flat side of each half on the print bed. To assemble, carefully guide the 4 clips to their slots.
**Update 08-23-2023** - added a version of the case top with a 16x16mm heatsink opening
sclebo05 veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
