Orange Pi Zero Case

This is a case for the Orange Pi Zero: http://www.orangepi.org/orangepizero/
Specifically, the original Orange Pi Zero with the H2+ CPU.

**CAUTION**:
* *This **will not fit** the Orange Pi Zero Plus2 (with the HDMI connector). It might fit the Orange Pi Zero Plus with the H5 CPU, but I don't have one to try.*
* *This case is for the Orange Pi Zero only, without the interface expansion board.*

If you do print this, consider the staggering amount of good karma that will come from providing feedback here. Even a short comment will do wonders.

OpenSCAD source shared in case you would like to make changes. Please respect the CC license. Source is also shared on github: https://github.com/phildubach/OrangePiZeroCase

The Orange Pi Zero that was used for taking measurements has its USB-A socket soldered in at a slight angle. I'm not sure whether that's the case for all units. However, even the one pictured at the orangepi site shows the USB connector slightly angled. If yours is