Thingiverse
Learning
Zum Modell
Orion
36
Downloads
28
Likes
0
Makes
Designed this Orion constellation to print in glow filament for kids' bedrooms.
Printing:
I printed at 75% size, .2 mm layers, and 100% infill. Printing at 33% size had some issues because the lines were too thin to easily remove from the buildplate. There was a minor issue where the line connecting the head stars to Betelgeuse didn't meet 100% that should be fixed in this STL that was there in the prints I did.
Printing:
I printed at 75% size, .2 mm layers, and 100% infill. Printing at 33% size had some issues because the lines were too thin to easily remove from the buildplate. There was a minor issue where the line connecting the head stars to Betelgeuse didn't meet 100% that should be fixed in this STL that was there in the prints I did.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
