OverEngineered Flashforge Creator Pro Spool Holders

I really like the Spool Holders created by arghhh40k and have used them for quite some time. But I had to go overkill and make new ones. I just learned a little about AUTODESK 123D Design software and put these together. Luckily you can easily add fillets and chamfers in 123D!!!

I found that I needed about 10 or so mm longer posts for the sainsmart PET spool and other spools I've bought. On these I extended the post, added a long taper, and reduced all stress concentrations by rounding all corners that might experience any stress. Lastly, I added indented identification text of "Left Side Spool" and "Right Side Spool" just in case there's any question or if you're not sure which side the Rep G software (or the printer) identifies as left and right.

Three files are posted; A file with both, and then one each for left and right if you would like to print them individually.

These print successfully in PLA with no raft and no support using Replicator G. Don't go over