Thingiverse
Overpass
von Grauenacht
19
Downloads
10
Likes
0
Makes
There are 2 variants for the collums: 3 regular pillars or 3 pillars on a base.
The overpass parts stay in place by themselves, just slide them in the part named "pillar", but I also prepared holes for 3x1mm magnets
They can be printed without supports
The overpass parts stay in place by themselves, just slide them in the part named "pillar", but I also prepared holes for 3x1mm magnets
They can be printed without supports
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!