MakerWorld
Board Games
Go to Model
Owlbear
99
Downloads
30
Likes
60
Makes
I am sure this beast can speak for itself, but just to be clear - before you stands an owlbear, half owl half bear. While I couldn't tell you why this for some reason makes it more dangerous than just a bear or just an owl, it sure is a fomidabble foe. This particular creature is made out of plastic though, so you should be safe (unless you try jamming it down your esophagus. Some practical details:It stands on a 50mm base. Prints just fine in PLA.Be careful when removing the supports around its claws though. Just take it slow and the claws should stay on.It is standing on a tactical rock which makes this particular owlbear more tactical than other owlbears (roll for advantage).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
