P1P Pegboard shell

Based on P1P official CAD enclosureIf you like the design, I would be flattered to receive a little tip via PayPal: PayPalIt is not fully tested but should work, please start with one corner first and see how it fits. Let me know if any adjustment needs to be made. -How to mount:The corner pieces attach with self tapping screws from inside and normal screws in the rear, these are supplied with the printer so you should have everything already.-Print Settings:I recommend using a minimum of 3 walls, top and bottom and infill of 20% or higher. Also, a wide enough brim is highly recommended to ensure bed adhesion, most parts are thin and tall.Please keep in mind that this design is published under a NON COMMERCIAL license, so please do not sell the design or prints made with this design.