P5 panel joiners

P5 panel joiners for the recent P5 panels sourced from LysonLED. Print at 3 or 4 walls and top and bottom layers for a decent strength, and I used 30% infill and printed in ABS, but cooler areas or inside may get away with PETG or PLA,

You will likely have to drill out the holes for the locating pins and screws as these were purposely made to be pretty tight, so any over extrusion or inaccuracies will cause them to be too tight

There are parts for the long and short edge joins, 2 types of corner joiners and the X connectors for the center of 4 panels. Also included is a "long edge small joiner" thats ideal for the middle of the long sides to keep the panels in line better.

I have also added a set that are designed for small magnets to be glued to the end. These can be used to stick 2 panels back to back, or a panel to a metal base.