Thingiverse
Pacman Ghost Lamp
von 3dpimp
30
Downloads
41
Likes
0
Makes
I designed this small lamp, just two walls and it has a small hole in the bottom to put some leds inside. I reccomend to print it upside Down and use support only touching build, It shouldn't need more than that.
layer height 0.2
infill density 10
support only touching build plate
temp 210
print speed 60
layer height 0.2
infill density 10
support only touching build plate
temp 210
print speed 60
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
