Thingiverse
Pacman Ghost Project
von thetazzbot
0
Downloads
0
Likes
0
Makes
I saw a large PacMan Ghost nightlight that I liked and decided to design one!
The backside is designed to accommodate LEDs, if you scale this to 50% you can use 2.5mm leds, otherwise it will use 5mm.
Full size this is 140mm wide by 140mm tall by 30mm deep. I've included the 123D file so you can download it and reshape it however you like.
NOTE:
I haven't assembled the two together yet, so you should double check fit in 123D Design.
The backside is designed to accommodate LEDs, if you scale this to 50% you can use 2.5mm leds, otherwise it will use 5mm.
Full size this is 140mm wide by 140mm tall by 30mm deep. I've included the 123D file so you can download it and reshape it however you like.
NOTE:
I haven't assembled the two together yet, so you should double check fit in 123D Design.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!