Paddle Rack

Howdy all,

So as you can see from the pictures this is a ping pong/table tennis racket holder, which also includes a tube which holds 4 ping pong balls.

The idea behind this originated from my workplace where we have a ping pong table set up (sounds like a pretty cruisy workplace I know), and attached to the side of this table is a makeshift net/zip-tie bag for our rackets, just stapled there, not doing a very good job.

SO, that's where this enters the stage, A 10mm thick, 4 racket, 4 ball holster ready to be put into action, the aim of this is to use those little sticky wall mounts to adhere it to the side of the table (instead of the DIY staple job).

I utilized the three individual pieces as it was easier to print and just needed to be glued together once done.

Everything can be printed without supports, the tube just needs to be printed upright to enable this, I haven't tried printing it horizontally.



There are multiple models for use dependent on you