PAHL table riser

I keep all of my 3d printing stuff on an Ikea PÅHL desk, and it became crowded between tools and stuff. So I got a cheap little rolling drawer tower to put underneath it to store everything. However, the drawers were about 12mm too tall to fit under it. So I made this to fit over the feet. It is designed to raise the desk by 10 mm, which it does well. I needed roughly two more mm for the cart, so I super glued some cut-up timing belts to the bottom to provide a bit of grip and the needed height. Unnecessary unless you need more height or grip like me though. Also, in the profile, I used a modifier to add a bit more strength vertically. I'm not really sure it's necessary, but better safe than sorry.