Thingiverse
Painters Hawk
von Bliv
1
Downloads
2
Likes
0
Makes
I didnt want to spend $40au on a Painters hawk to mix dry wall/gyprock powder and fill a few small holes in my interior walls so i designed this one in Onshape and printed my own.
Printed on a smooth plate using PETG so it can be washed clean after use.
I added 3 small feet so it can be temporarily put down without the handle and leave enough room to get your fingers under it to pick it up when ready to use again.
EDIT: added an improved version thats square so you can scrape your spatula clean on the straight edge of the hawk. (cant do this on the round one)
Printed on a smooth plate using PETG so it can be washed clean after use.
I added 3 small feet so it can be temporarily put down without the handle and leave enough room to get your fingers under it to pick it up when ready to use again.
EDIT: added an improved version thats square so you can scrape your spatula clean on the straight edge of the hawk. (cant do this on the round one)
Bliv veröffentlicht auch auf
16 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
