Palm Tree

This is a set to built individual palm trees.

Please condider this print settings

trunk
has to be printed in vase mode using a 0,8mm nozzle
line width, 0,8mm
layer height 0.2mm

leave
printed in "normal" mode 0,4mm nozzle
line width 0,46mm (less infill is used what can otherwise make a lot of mistakes
layer height 0.15mm

For easy mounting I put a steel wire through the trunks and glued the leave on top of the last trunk. Wit a heat gun I blowed the leaves in the right position.

Hint: you can print a lot of leaves or trunks in one go using print sequence "one at a time" in Cura. Therefore I added the print ready Cura project *.3mf files for may Anycubic Mega-S