Panda Den Insert

I was annoyed about the amount of poop that jumped on the plate in panda den and landed outside the drawer. These poops are hard to remove again, so i created an insert for the Panda Den. Even when the inset is in place, you can still open the drawer, so you can empty it to wast. It needs to be printed in TPU og TPU for AMS. (I have used the later) in order for the model to be flexible enough to come in and out of the Den it self. The easiest way to install the inset, is to empty the drawerplace the inset in the middle of the drawer, and bend the to so you can close the drawer with the insetAfter the inset is inside the Panda Den, slide it to the back. (This may require some bending of the bottom, in order to slide by the two screw holes)I have printed this in 0.24 mm layer height in order to cut down time. But that is totally up to you.