MakerWorld
3D Printer Accessories
Zum Modell
Panda Touch Mount
4
Downloads
3
Likes
0
Makes
This is a mount for the Panda touch using the HKR Build Plate Storage - Stackable - Under AMS designed by Hiro Koiso RacingIt uses x7 - 12x3mm round magnetsx4 M4x12 countersunk screws x4 M4 Nuts Once the part has been printed you would need to super glue the magnetics into the 5 holes in the rear Then you can install the panda touch mount using the M4 screws and nuts Boost Me
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
