Parameteric Swatch Spinner

A swatch spinner based strongly on the design here: https://makerworld.com/en/models/506640#profileId-422370 I wanted one larger then those available. It is configurable in multiple sizes. 150, 200, 300, and 375 swatches. I haven't tried the larger ones, but they should work. You can also configure the direction of the ramp, or allow it to move in both directions. The profile I uploaded has variable layer heights to smooth the ramp. You will need one 608 bearing to hold the parts together, and I would recommend a single m5 between 8 and 12mm. The bolt reinforces the bottom so it is less likely to snap, but the entire thing is friction fit together and you should not expect to be able to get it apart without breaking the plastic of the bottom. This is the smaller and faster piece to reprint if it does break.