Thingiverse
Parameterized tone wheel
por gcdanie
6
Descargas
3
Likes
0
Makes
This is a parameter-generated tone wheel generated in openSCAD. The defaults set it up for a Silvermine Motors big brake kit for a 240Z, but are adaptable to basically any rotating shaft.
The .scad file will allow any parameter tweaking for your particular use case.
It's not a stressed piece of any rotating assembly, so your filament selection should reflect the type of environment it is intended for use in. In my case, nylon will do the job.
The .scad file will allow any parameter tweaking for your particular use case.
It's not a stressed piece of any rotating assembly, so your filament selection should reflect the type of environment it is intended for use in. In my case, nylon will do the job.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
