Thingiverse
Parametric Basket
von aarmijo
164
Downloads
120
Likes
0
Makes
A parametric basket with holes to put plants in an aquarium. The dimensions of the basket, grid holes and top edge support can be modified.
The length of holes on the bottom grid must be adjusted by hand through the vector "p" that stores the length of the holes depending on the available space. 1 means all space, 0.5 half space and so on. The first value corresponds to the hole closest to the edge and the last to the hole closest to the center. All values must add 1. The number of elements in this vector determines the number of rings in the bottom grid.
Limitations:
- The maximum number of ring of holes in the bottom grid is 5.
- The length of the holes in the bottom grid can not be less than its width.
- Slow rendering time. Almost 5 minutes on an Intel Core I3 with 4 GB ram.
The length of holes on the bottom grid must be adjusted by hand through the vector "p" that stores the length of the holes depending on the available space. 1 means all space, 0.5 half space and so on. The first value corresponds to the hole closest to the edge and the last to the hole closest to the center. All values must add 1. The number of elements in this vector determines the number of rings in the bottom grid.
Limitations:
- The maximum number of ring of holes in the bottom grid is 5.
- The length of the holes in the bottom grid can not be less than its width.
- Slow rendering time. Almost 5 minutes on an Intel Core I3 with 4 GB ram.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
