Parametric Bezel Maker

I needed a Bezel for my ADX5, to keep it from LCD sliding off. Needed something deep to make it hit the back enclosure So I used OpenSCAD and its parameters, to setup my Bezel. Though I would share it, since its parameterized There is an option to add a name section so you can name your bezel or printers. You can also add small clips to lock it in place. The parameters: Inside Depth (mm) - depth from front to make. The clip if added will add to the depthInside Width (mm) - how wide is the bezelInside Height (mm) - how high is the bezelcorner radius (mm) - how much to round the corners, to tight and it wont fitwall thickness (mm) - how thick are the walls.lip width (mm) - how wide to make the overhangclip sides - if you want retention clips, none, 4 sides, top/bottom,. left/rightwidth of clips (mm) - how wide to make the clipsdepth of clips (mm) - how deep to make them, note to deep and it won't fit.name plate width (mm) - how wide to make name plate (width ≤ 0 no plate)name plate h