Thingiverse
Parametric button cell holder
door NilsR
23
Downloads
12
Likes
0
Makes
Untested design, please report any issues!
A holder for a single button cell. It can be adjusted to almost any battery, or multiple cells if you add the height of the cells.
Usage: Print and stick two pieces of wire through the holes in the sides. Slide in the button cell. If the fit is too tight, modify the parameters, starting with tolerance. Likewise if the fit is too loose, set tolerance to a smaller value.
Example files:
CR1225 cell holder:
diameter=12mm
height=2.5mm
tolerance=0.5mm
wall thickness=2mm
CR2032 cell holder:
diameter=20mm
height=3.2mm
tolerance=0.5mm
wall thickness=2mm
A holder for a single button cell. It can be adjusted to almost any battery, or multiple cells if you add the height of the cells.
Usage: Print and stick two pieces of wire through the holes in the sides. Slide in the button cell. If the fit is too tight, modify the parameters, starting with tolerance. Likewise if the fit is too loose, set tolerance to a smaller value.
Example files:
CR1225 cell holder:
diameter=12mm
height=2.5mm
tolerance=0.5mm
wall thickness=2mm
CR2032 cell holder:
diameter=20mm
height=3.2mm
tolerance=0.5mm
wall thickness=2mm
NilsR publiceert ook op
13 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
